Husqvarna PG 830 Propane Manual Del Usuario página 16

1. Make sure that the propane tank is tightly held
in position by the lock and the holder plate. The
propane tank cannot move when the propane tank
is correctly installed.
2. Connect the propane hose from the product to the
propane tank.
3. Make sure that the propane hose is correctly
connected to the fuel valve on the engine.
4. Make sure the all couplers are in line. Tighten the
couplers by hand to connect the propane tank to the
product.
CAUTION:
complete the connection of the propane
tank to the product. The couplers can be
damaged.
5. Turn the propane tank valve counterclockwise until it
stops to start the flow of the propane.
6. Do a soap test on all propane lines. Refer to
examine the propane tank and lines on page 21 .
7. Disconnect in the opposite sequence.
To start the product
1. Connect the propane tank. Refer to
disconnect the propane tank on page 15 .
16
Do not use a tool to
To
To connect and
2. Turn the main switch clockwise.
3. Pull out and turn the throttle control to idle speed for
the engine. Refer to
4. Turn and hold the ignition key to engine start
position.
5. When the engine starts, immediately release the
ignition key. The ignition key goes to the "1" position.
CAUTION:
engine for more than 5 seconds at a
time. If the engine does not start, wait
15 seconds before you try again.
6. Before you operate the product, wait 3-5 minutes
and let the engine become warm at idle speed. Refer
Rpm for the engine on page 5 .
to
To operate the product
CAUTION:
time while the grinding head is on. If you
do not move the product, the surface can
become rough.
Rpm for the engine on page 5 .
Do not try to start the
Move the product all the
2023 - 003 - 04.04.2023