VALBERG UF NF 194 E W180C Instrucciones De Uso página 6

B
Using the appliance
Reversing the door
The direction in which the door opens can be changed from the right side (as supplied) to the left
side, should the placement of the appliance require this change.
CAUTION :
When changing the side where the door opens, the appliance
must not be powered. Make sure that the plug is removed
from the power socket.
Tools you will need
Not included
8mm socket spanner Thin-bladed screwdriver
Phillips screwdriver Pipe spanner
Additional parts (in the plastic bag)
Left hinge cover
PLEASE NOTE :
If necessary, you can place the refrigerator on its rear side
to gain access to the base. It can be placed on a soft foam
packing or similar material to avoid damage to the rear
panel of the refrigerator. To reverse the door, the following
steps are generally recommended.
Putty knife
8mm spanner
8 EN
B
Using the appliance
C
Use a putty knife or thin-bladed screwdriver to fix the screw cover in the upper left corner of
the refrigerator and the hinge cover in the upper right corner of the refrigerator.
D
Unscrew the special self-tapping screws from the flange used to secure the upper right-hand
part of the hinge using an 8 mm socket screwdriver or a spanner (when doing so, be sure to support
the upper door with your hand).
E
Remove the top pin from the hinge, transfer it to the upside-down side and tighten it firmly,
then place it in a safe place.
F
Remove the door from the lower door.
PLEASE NOTE :
When removing the door, be aware that the washers
between the bottom hinge and the bottom of the bottom
door may stick to the door. Do not lose them.
G Place it on a smooth surface with the panel facing up. Unscrew the screw
and the part a , then install them on the left side and tighten them firmly.
H
Place the refrigerator on some soft foam packing or similar material. Remove the two lower
parts of the adjustable feet and the lower part of the hinge by unscrewing the special self-tapping
screws from the flange.
I
Replace the lower part of the hinge to the left and secure it with the special self-tapping screws
on the flange. Replace the lower parts of the adjustable feet on the other side and secure them.
J
Transfer the door to the proper position, adjust the lower hinge part, insert the hinge pin into
the lower hole of the door.
K
Transfer the upper part of the hinge, insert the upper hinge pin into the upper hole of the door
and adjust the position of the door (holding it with your hand), fixing the upper part of the hinge
with the special self-tapping screws of the flange.
9 EN
b