Battery Pre-Alarm; Battery Main Alarm; Device Alarm - Dräger X-zone 5000 Instrucciones De Uso

8.3

Battery pre-alarm

The alarm is indicated by an intermittent
alarm message:
Acknowledging the pre-alarm:
The Battery LED flashes red.
Press the key. Only the audible alarm will be switched
 OK
off.
The battery lasts another approx. 15 minutes after the
battery pre-alarm.
8.4

Battery main alarm

The alarm is indicated by an intermittent
alarm message:
Only the acoustic signal of the main alarm can be
acknowledged.
The Battery LED flashes red.
The device automatically switches off after 10 seconds.
The visual and the audible alarm will be activated for a short
time before the device switches off.
8.5

Device alarm

NOTICE
i i
The device error can be in the X-zone 5000 or the
X-am 5000/5600.
An error code is only displayed with a local device error. The
error code of the first error (with the lowest number) is
displayed. If there are multiple local device errors, these can
be displayed either via Info Mode (see chapter 3.1.4 on
page 39) or the device must be exported using the PC
software Dräger CC-Vision (see chapter 10 on page 56).
The alarm is indicated by an intermittent
alarm message:
Display with grouped devices:
Dräger X-zone 5000
ARCL-0144
ARCM
X5
0009
ALL
04933112.eps
Display with ungrouped
devices:
The device or one or more sensor channels are not ready

for operation.
Remedies, see chapter 11 on page 57

If necessary, commission DrägerService to eliminate the

error.
To acknowledge the device alarm:
Press the key.

OK
Alarms (default settings)
O Vol%
2
20.9
0
ppm
1
X16
ALL
05033112.eps
53