Publicidad
Idiomas disponibles
Idiomas disponibles
Child Restraint Only Install
This child restraint can be installed
without a base in 3 different ways.
1
- Place vehicle in park and on
level ground. Position child
restraint so that child is facing
the rear of the vehicle.
Only install in a forward facing
vehicle seat.
2
- Option 1: Route the vehicle lap
belt under both lap belt guides.
Buckle the vehicle belt. Allow
shoulder belt to lay against
vehicle seat back as shown.
3
- Option 2: Route the vehicle
lap belt under both lap belt
guides. Buckle the vehicle belt.
Route the shoulder belt around
the back of the child restraint
passing through the blue
shoulder belt guide.
4
- Option 3: If your vehicle does
not have a shoulder belt, the lap
belt only can be used.
5
- Adjust the angle of the child
restraint. A rolled up towel or
foam pool noodle may be used
to adjust the amount of recline.
6
- Angle is correct when blue line
on child restraint (located on
the label on the side of the child
restraint) is level with ground.
(continued on the next page)
52 PIPA lite rx instructions
1
2
3
4
5
6
PIPA lite rx instructions
53
Publicidad
