Publicidad
Idiomas disponibles
Idiomas disponibles
2. Press the battery release button to release
battery pack from your tool.
Adjusting the bike handle (See Fig. G)
G
1. Loosen the clamp bolt and adjust the bike handle
to find the suitable position.(See Fig.G)
2. Tighten the clamp bolt until the handle cannot be
moved.
Adjusting the harness (See Fig. H)
H
EN
1. Adjust the length of harness strap to make it
comfortable during operation while connecting
the hip pad to the brush cutter.
Balancing the Brush cutter (See Fig.I)
I
12
1
2
1
1
1. Put on the harness and connect hip pad to the
brush cutter. Let the cutter hang on the harness
until it stops moving.( The cutting attachment
or the trimmer head should be relaxed over the
ground).
Note: Adjust the connection between the hip
pad and brush cutter if the brush cutter is not
properly balanced.
OPERATION:
Starting the brush cutter (See Fig. J1, J2)
J1
J2
2
1. Connect the hip pad to the brush cutter.
2. Hold the brush cutter firmly with your right hand
on the control handle – wrap your thumb around
the handle. Hold the cutter with your left hand
on the auxiliary handle– wrap your thumb around
the handle.
3. Hold and press the On / Off Switch until the
green LED is lit. The green LED shows the power
level.
4. Press the Operator Presence Switch first, then
press the Throttle Trigger to start the machine.
The green LED for start/stop indication goes off
after 5 seconds and the product needs to be
restarted.
NOTE: The Operator Presence Switch is designed
to prevent accidental operation. When you press the
Operator Presence Switch it releases the Throttle
Trigger.
1
3
Publicidad
