Publicidad
Idiomas disponibles
Idiomas disponibles
L1
L2
EN
L3
1. Insert the replacement line through the eyelet
(LINE IN) and feed it through the other side.
Ensure both ends of the line are even on each
end of the trimmer head (recommended 4.5m)
and cut the line. (See Fig. L1,L2)
3. Turn the knob clockwise to wind the line around
the spool until about 16cm remains on either
side. (See Fig. L3)
14
Lubricating the gearbox (See Fig. M1, M2)
M1
M2
4.5 m
(15 ft)
4.5 m
(15 ft)
1. Remove the screw on the gearbox.
2. If there is no grease on the end of the screw,
squeeze 5 g of the gear grease into the gear
housing.
3. Refit and tighten the screw firmly.
4. Install the battery and run the brush cutter for 1
minute to ensure the gear is evenly lubricated.
Cleaning the air filter (See Fig. N1, N2)
N1
Publicidad
