Publicidad
Idiomas disponibles
Idiomas disponibles
Li-Ion battery, battery must be
recycled
Do not burn
Batteries may enter water cycle if
disposed improperly, which can
be hazardous for ecosystem. Do
not dispose of waste batteries as
unsorted municipal waste.
Make sure the battery is removed
1
2
prior to changing accessories.
WARNING – Beware of blade
thrust
Trimming
Positec Inc. has established a partnership with
the RBRC Corporation to recycle any Positec
batteries with the RBRC-call2recycle seal. For
environmental protection, please do not discard
batteries in the trash.
After the batteries' life cycle is ended, then
please call 1-800-822-8837 for a free service that
will properly dispose of the battery.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the bike handle (See Fig. A)
A
1. Remove the battery pack before assembling the
bike handle.
2. Place the bike handle(a) into the lower clamp
molding(e). Then place the upper clamp molding
(b)and clamp screw(c) in order as shown. Finally,
tighten the screws(d) to finish the assembly.
Disassembly and assembly of the safety guard
WARNING:
1. The battery pack must be remove before
assembling or unassembling the safety guard.
2. In order to reduce risk of injury and show
maximum performance of cutting, the safety
guard and cutting attachment must be approved.
Assembling the safety guard (See Fig B1,B2)
1. Place the safety guard into the position until the
safety guard is tight against the position.(See Fig
B1)
2. Tighten the screws with wrench to make sure the
safety guard does not move during operation.
(See Fig B2)
B1
1
c
a
d
b
e
1
EN
9
Publicidad
