Publicidad
Idiomas disponibles
Idiomas disponibles
Selecting the speed(See Fig. J3)
J3
1. Power Levels can be selected depending on the
application. Use the +/- to control the speed,
which is as indicated by the LEDs. The higher the
power level, the faster the tool runs.
Stopping the brush cutter
Release the Throttle Trigger to stop the machine.
WARNING! The cutting head continues to
rotate after the cutter has been switched off;
wait until it has completely stopped then lay down
the tool.
Choose the suitable blade for the
application (See Fig. K1, K2)
K1
K2
1. When working with tirmmer head and skirt, move
the brush cutter back and forth on the ground as
Fig K1 shown.
2. When working with cutting blade, sweep the
brush cutter parallel to the ground in front of you.
To reduce the risk of kick back, use the left side
of the cutting blade.
NOTE
1. Use the tip of the cutting line to do trimming; do
not force the trimmer head into uncut grass.
2. Wire and picket fences may cause extra cutting
line wear and breakage. Stone and brick walls,
curbs, and wood may wear cutting line rapidly.
3. Avoid trees and shrubs. Tree bark, wood
moldings, siding, and fence posts can easily be
damaged by the cutting line.
4. The selected power level affects the battery's
runtime. The lower the power level, the longer
the runtime. It is recommended to use the lowest
power level unless in worse cutting condition.
TRANSPORTATION
Transporting the Brush cutter
1. Switch off the brush cutter and remove the
battery.
2. When transporting your brush cutter by hand,
hold the middle of shaft to make sure that your
machine is parallel to the ground.
3. When transporting your brush cutter in a vehicle,
secure and position it to prevent movement or
damage.
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
MAINTENANCE
WARNING! Always remove battery before
conducting any maintenance on the brush
cutter.
WARNING! Use of wire or metal-reinforced
line is not authorized and could be
extremely dangerous. Use only the cutting line
recommended in this manual, in combination
Winding the line (See Fig. L1, L2, L3)
EN
13
Publicidad
