Publicidad
Idiomas disponibles
Idiomas disponibles
FAQ
EN
The Clean Water Tank is not
properly installed in place, or the
water in the Clean Water Tank is
No water is coming
It takes 30 second to dampen the
brush roller
A collision or a sharp pull causes
water to enter the motor
The vent leaks water
after being cleaned
The brush roller may be jammed
The appliance is not placed onto
the charging base properly
Self-cleaning cannot be enabled if
Self-cleaning fails
the battery level is lower than 15%
The Clean Water Tank is not
installed in place, or the water in
Poor drying
performance or
The air outlet and air inlet of the
strange noise while
charging base may be blocked
drying
For additional services, please contact us via aftersales@dreame.tech
Website: https://global.dreametech.com
15
15
Tank
Turn on the appliance and
check again in 30 seconds
use
Open the brush roller cover
to check and clean the brush
roller
Make sure the appliance is
being charged before self-
cleaning
The self-cleaning function can
only be enabled when the
appliance is being charged and
the battery level is more than
15%
Water Tank
Tank
Check and clear the blockage
of air outlet and air inlet
Troubleshooting
If the appliance is not working properly, the screen display will show an error message.
Error
Possible Cause
Icon
Clean Water Tank
The Used Water Tank is
full
Brush roller stuck
Brush roller not
installed
Blocked tube
Troubleshooting
Possible Cause
Code
E1-E7
Error
H1-H6
H7
Battery overheating
Solution
Fill the Clean Water Tank
Empty the Used Water Tank
Clean the brush roller with the provided
cleaning brush
Install the brush roller
sensor
Solution
Restart the appliance for
troubleshooting. If the problem
persists, please contact customer
service
Wait until the battery's temperature
returns normal
EN
16
16
Publicidad
