Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
WARNING
Keep your arms and face away from being directly above
the cooking area while in operating the appliance.
DANGER
● The top glass cover must be kept open when lighting and
using the cooktop.
● Do not attempt to light more than one burner at a time.
Lighting the Cooktop
NOTE: This range is equipped with a flame detection device
on the each cooktop burner and the oven burner. During the
lighting process, ensure that the knob is held in for 5 to 10
seconds once the burner is lit to heat up the thermocouple. If
not held in long enough, the flame detection device will stop
gas flow to the burner.
Before lighting, check and make sure all the control knobs
are in the OFF position. Make sure the main gas tank valve is
opened.
Standard Ignition:
1. Lift to open the cooktop top glass cover. (Fig. 12) The top
glass cover must be kept open when lighting and using the
cooktop.
Fig. 12
2. Push and turn the appropriate burner control knob
counterclockwise to the
CCD-0005608 Rev: 08-28-23
position. (Fig. 13)
Fig. 13
3. Keep the burner control knob pushed in and turn the
ignition knob clockwise repeatedly until the burner is lit.
(Fig. 14)
Fig. 14
4. Once the cooktop burner is lit, keep the burner control
knob pushed in for 5 to 10 seconds.
5. Rotate the burner control knob to adjust the flame to
desired level.
6. Repeat steps 2 and 5 to light the other burner(s) as
required.
If the burner does not ignite
In the event of failure to light the burner within 5 seconds,
immediately turn the control knob clockwise to the OFF
position. Wait at least 5 minutes and repeat the igniting
procedure. If ignition still not occur, use a gas lighter or a
match to light the burner. Refer to the 'Manual Ignition'
section.
Manual Ignition
Use care when lighting the burners by hand. If a burner
lights unexpectedly, or your hand is to close to the burner,
you could be burned.
In the event of failure to ignite the burner in standard ignition,
you may light the burner manually by following the steps
below:
1. Turn the appropriate burner control knob
counterclockwise to the
- 10 -
WARNING
position. (Fig. 15)
Publicidad
