Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
● Make sure all the control knobs are off and the appliance is
cool before cleaning.
● Make sure all the appliance surfaces, burner grates and
burners are cool before cleaning or disassembling.
● DO NOT use bleach or rust removers on the cooktop or
burner grates.
● DO NOT obstruct the flow of combustion and ventilation air.
● Keep the appliance area clear of combustible materials,
gasoline and other flammable vapors and liquids.
● Never use a wire brush or metallic item for cleaning burner
ports or orifices. Brush may "shed" bristles that may lodge in
the orifice or burner ports and cause a fire or explosion.
● Clean all surfaces as soon as possible after boilovers or
spillovers.
● Use warm soapy water only to clean the burner grates,
cooktops, painted surfaces, porcelain surfaces, stainless
steel surfaces and plastic items on your range or cooktop.
Do not use grit or acid-type cleaners. Do not use cleaners
with ammonia, Cleaners of these types are corrosive and
could damage component parts in the range.
● DO NOT use steel wool, or abrasive cleaners, or acid type
cleaners such as chlorine bleach on your cooktop or grate
systems. They will damage your range or cooktop. Use only
non-abrasive plastic scrubbing pads.
● DO NOT allow foods containing acids (such as lemons or
tomato juice, or vinegar) to remain on porcelain or painted
surfaces. Acids may remove the glossy finish. Wipe up egg
spills when cooktop is cool.
● DO NOT wash warm porcelain surfaces. Allow these areas
to cool before cleaning. You could burn yourself or the
porcelain could crack.
● Pitting and discoloration will result if spills are allowed to
remain for any length of time on stainless steel.
● DO NOT allow spillovers to remain on the burner caps. The
caps could become permanently stained.
● When cleaning around the burners use care to prevent
damage to the electrode (if so equipped). If a sponge or
cloth should catch the metal igniter electrode, it could
damage or break the electrode. If this occurs the burner will
not light.
Replacing the Control Knob LED
1. Disconnect the oven from the power supply by means of
the switch used to connect the appliance to the electrical
mains, or unplug the appliance if the plug is accessible.
2. Grasp and pull on the control knob with the broken LED
light. (Fig. 18)
CCD-0005608 Rev: 08-28-23
Fig. 18
3. Remove the two screws holding the LED light using a
Phillips screwdriver. (Fig. 19)
Fig. 19
4. Remove the LED assembly and disconnect the wire from
the base of the LED assembly. (Fig. 20)
Fig. 20
5. Plug the wire harness connector into the new LED
assembly.
6. Reattach the LED assembly to the console with the
2 screws removed in step 3. Ensure the wires are not
pinched during this process.
7. Reattach the control knob by aligning the stem of the
control into the opening in the control knob housing and
pushing it back into position.
- 12 -
Publicidad
