MC-5455630-Bedien-1211_a 08.12.11 16:52 Seite 60
Fig. 3
11
Caution! Ensure that the sanding
belt is free of bends!
When changing the belt, ensure that the
direction of the arrow on the inside of
the sanding belt matches the one on the
housing of the unit. The sanding belt
must sit flush with the right-hand edge
of the sanding disc (11). Return the
tensioning lever back to position.
Operate the belt adjuster (5) to adjust
the belt run. Turning the adjuster screw
left or right with the machine running
allows you to exactly set the belt to run
straight parallel to the right-hand edge
of the sanding disc (11). If you do not
perform this adjustment, the sanding
belt will be damaged. Sanding belts that
show considerable wear should be
replaced.
Dust collection mechanism
The electrical tool has a
mechanism that enables you to
collect or vacuum the sanding
dust.
• Slide the dust collection bag opening
as far as it will go onto the exhaust
opening (12) on the housing. The bag
is closed using a zip. Emptying the
bag frequently increases the exhaust
performance.
60
Fig. 4
8
• Household vacuums are also suitable
for use. You may need to obtain a
connection element that fits in order
to do so.
collection mechanism attached.
8 – Operation
Switching on
Press down switch (1) and hold (Figure 5).
Switching off
Release switch (1).
Fig. 5
Switching on continuous operation
Press the switch (1) down, press the
button (2), release the switch (1)
(Figure 5).
Caution! Wood dust is dangerous!
Thus, always work with the dust
12
2
1