Publicidad
Idiomas disponibles
Idiomas disponibles
times.
b)
Stop the blade(s) when crossing gravel drives,
walks, or roads.
c)
After striking a foreign object, stop the motor,
unplug, thoroughly inspect the mower for
any damage, and repair the damage before
restarting and operating the mower.
d)
If the equipment should start to vibrate
abnormally, stop the motor and check
immediately for the cause. Vibration is generally
a warning of trouble.
e)
Stop the motor and unplug whenever you leave
the equipment, before cleaning the mower
housing, and before making any repairs or
inspections.
f)
Shut the motor off and wait until the blade
comes to a complete stop before removing the
grass catcher or before unclogging the chute.
g)
Mow across the face of slopes, never up and
down. Exercise extreme caution when changing
direction on slopes. Do not mow excessively
steep slopes.
h)
Never operate the mower without proper
guards, plates, or other safety protective
devices in place.
i)
Do not wash with a hose, avoid getting water in
motor and electrical connections.
1.4 Maintenance
a)
Check the blade and the motor mounting bolts
at frequent intervals for proper tightness.
b)
Keep al nuts, bolts, and screws tight to be sure
the equipment is in safe working condition.
c)
Check bag frequently for deterioration
and wear, and replace worn bags. Check
that replacement bags comply with the
original manufacturer's recommendations or
specifications.
d)
Replace the blade if it is bent or cracked. An
unbalanced blade causes vibration that could
damage the motor drive unit or cause personal
injury.
e)
Sharpen a dull blade equally at each end to
maintain the balance.
f)
Clear the blade thoroughly and check its
balance by supporting it horizontally on a thin
nail through its centre hole. The mail should
also be in a horizontal position. If either end
of the blade rotates downward, remove some
metal from the heavy or lower end until the
blade is balanced. It is balanced when neither
end drops.
SAVE THESE INSTRUCTIONS
USER MANUAL
REQUIREMENTS FOR
WIRELESS PRODUCT
a) This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
b) Caution: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
c) This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
d) NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
EN
9
Publicidad
