Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY PRECAUTIONS
READ THESE INSTRUCTIONS CAREFULLY AND
RETAIN FOR FUTURE REFERENCE.
Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
1.
This appliance must be disconnected from its power source during installation or service activities
and when replacing.
2.
The Krystal is not equipped with an integrated device to control the room temperature. If intended
for use in an enclosed space for the purposes of room heating, Herschel iQ controls must be used. If
you do not fit a room temperature controller,
occupied by people incapable of leaving the room on their own, unless constant supervision is
provided. Herschel is not responsible for any breach of EcoDesign or Safety legislation where the
heaters are used in an enclosed space without use of a Herschel iQ controller.
3.
To avoid overheating and potential fire hazard,
DO NOT
locate the heater within 1m (39") of any flammable materials (e.g., Furniture, curtains).
DO NOT
4.
touch the heater when in use. Surface temperatures of Krystal heaters exceed 250°C /
482°F. Contact with the heater will cause burns and injury. Switch off the heater and allow to cool for
at least 10 minutes before touching any part of it.
DO NOT
5.
operate the heater if the cord is damaged or after the heater malfunctions, or if it has been
dropped or damaged in any manner. Check each heater for damage before installation. Make sure
that the heater itself and its power cord are free of any visible signs of damage. If the cord is damaged
the appliance must be sent for repair to an authorised Herschel Dealer.
6.
This heater must only be used for the heating of people or buildings. The heater is not to be used by
children or persons with reduced physical, sensory or mental capabilities, or lack of experience or
knowledge. Children should be kept away and should not be left unsupervised around the unit.
NOT
use outdoors.
7.
All operators should only switch on/off the appliance provided that it has been placed or installed in
its intended operating position in accordance with these instructions. Children must not plug in,
switch on or regulate the appliance or perform user maintenance including cleaning.
8.
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50/60 Hz AC. If your
supply voltage exceeds 240 Volts do not use the heater and refer to your local dealer. Failure to
adhere to this will void the warranty.
9.
The heater must be mounted on a non-flammable surface.
SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION:
Krystal heater panels are rated to a standard (minimum IP44) enabling them to be located within zone 2 in
a bathroom. This means they can be placed above a sink or outside any splash zones, or they can be installed
on the ceiling. They cannot be installed in zones 0 or 1.
DO NOT
use for room heating when rooms are
DO NOT
cover the heater under any circumstances.
ENGLISH
DO
Publicidad
