Publicidad
Idiomas disponibles
Idiomas disponibles
Steps:
1. Use 4 self-tapping screws to attach two brackets to the rear of the heater.
2. Mark on the ceiling or wall in the intended position the four drill holes using the brackets as a template
(234mm apart & 50mm between the holes on each bracket).
3. Drill the 4 holes and insert the supplied rawlplugs. Screw the other half of the bracket pair onto the
ceiling or wall using the 4 x long tapping screws supplied.
4. Form a hinge between the brackets using the 4 x bolts, 4 x washers and 4 x butterfly nuts and tighten
the butterfly nuts so the angle of the hinge is set and no further swiveling of the hinge is possible.
ENGLISH
Publicidad
