Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
4.3.6
Optional motor control board (MSP)
Pinout of plugs:
All voltage connections are protected against polarity reversal. The drive hous-
ing is not provided with earthing. The signal inputs are galvanically isolated from
the supply voltage. The drive is designed for a fixed connection to a direct volt-
age source.
3-pin plug (large):
4-pin plug (small):
Electrical parameters:
Designation
V
(rated voltage)
SS
I
(quiescent current)
SO
I
, I
, I
(signal inputs)
A
E
F
I
, I
, I
- 0-Signal
A
E
F
I
, I
, I
- 1-Signal
A
E
F
t
(delay time)
V
I
(current for overload cut-off)
Ü
Tab. 8 Electrical parameters
Overload cut-off:
If enable is pending and a travel direction signal is issued, delay time "t
running. Only after "t
higher motor start-up current. If motor current rises above "I
energised. It can only be put into operation again after briefly deactivating the
enable or the direction of travel signal.
1 – GND (ground/earth)
2 – Vss (supply voltage)
^
– Housing
1 – I
(input, direction of travel signal "Moved out")
A
2 – I
(input, direction of travel signal "Moved in")
E
3 – I
(input, enable)
F
4 – GND (ground/earth)
Condition
V
SS
V
SS
" has elapsed is the overload cut-off active for gating the
V
min.
nom.
+ 18
+ 24
= 24 V
+ 25
- 30
- 30
+ 13
+ 24
= 24 V
120
approx. 6
max.
Unit
+ 30
V
mA
+ 30
V
0
+ 8
V
+ 30
V
ms
A
" starts
V
", the motor is de-
Ü
23
Publicidad
