Testing A Torque Wrench With The Torque Tester - Gedore Dremotest E 8612-012 Manual De Instrucciones

Output in standard ASCII format. Sample output:
***
DREMOTEST-E 8612-050 SNR. 99999
SCHLUESSEL-/Wrench-No.:____________
No.
001 --------------------- 02.68 N.m
002 --------------------- 01.02 N.m
003 --------------------- 01.44 N.m
The header phase and the tally of the reading starts again
when the power supply is plugged in.
3.7

Testing a Torque Wrench with the Torque Tester

The torque tester can be overloaded during use and break
causing SERIOUS INJURY or DEATH.
ALWAYS use only original accessory parts. Accessory parts
not approved by the Gedore may not bear the loads or cause
the torque tester to overload.
ALWAYS inspect the torque tester for damage BEFORE use.
NEVER use a damaged torque tester.
NEVER use the torque tester if it has been dropped, if it has
been used to strike other objects, or if anything has fallen on
it.
An out-of-calibration torque tester can result in the failure of
the screw connections, the torque wrench, or the accessories.
This could cause SERIOUS INJURY or DEATH.
An out-of-calibration torque tester may cause the torque
wrench settings to be over- or under- torque, resulting in
SERIOUS INJURY or DEATH.
Always use tested and calibrated torque testers ONLY
(see Section 4.1Testing and Calibrating).
EN
GEDORE
MESSWERT/Value
WARNING
OVERLOAD HAZARD
WARNING
INACCURATE TORQUE SETTINGS
16
***