Publicidad
Idiomas disponibles
Idiomas disponibles
STARTING/STOPPING THE MACHINE
WARNING:
machine. Do not wear loose clothing or jewelry. Wear eye and ear/hearing protection.
Wear heavy duty, long trousers, boots and gloves. Do not wear short trousers, sandals
or go barefoot.
To start the machine (Fig. 8)
1. Move the lock-off lever up until it
completely fits into the groove, hold
it in that position and then press the
trigger switch to start.
2. The rotational speed of the cutting
unit is controlled by the trigger
switch. More pressure on the
trigger results in higher speed; less
pressure on the trigger results in lower speed. Adjust the speed to suit the task at
hand.
NOTICE: The motor starts only when the lock-off lever is moved into the groove and the
trigger switch is depressed at the same time.
To stop the machine
Move the machine away from the cutting area and release the trigger switch to stop it.
WARNING:
breaks and after finishing work.
56-VOLT LITHIUM-ION COMMERCIAL 12" BRUSH CUTTER — BCX4500/BCX4500-FC
Dress properly to reduce the risk of injury when operating this
Always remove the battery pack from the machine during work
8
1
Lock-off Lever
2
Trigger Switch
Speed Mode Button
29
Publicidad
