Publicidad
Idiomas disponibles
Idiomas disponibles
ADJUSTING THE CUTTING LINE
LENGTH
The trimmer head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or
worn, additional line can be released by
lightly tapping the trimmer head on the
ground while operating the trimmer.
WARNING:
the line-cutting blade assembly. Excessive line length will cause the motor to overheat
and may result in serious personal injury.
Tips for best trimming results
The correct angle for the cutting attachment is parallel to the ground.
◾
Do not force the trimmer. Allow the very tip of the line to do the cutting (especially
along walls). Cutting with more than the tip will reduce cutting efficiency and may
overload the motor.
◾
The cutting height is determined by the distance of the cutting line from the lawn
surface.
◾
Grass over 8 inches (20 cm) should be cut by working from top to the bottom in
small increments to avoid premature line wear or motor drag.
◾
Slowly move the trimmer into and out of the area being cut, maintaining the
cutting head position at the desired cutting height. This movement can be either
a forward-backward motion or a side-to-side motion. Cutting shorter lengths
produces best results.
◾
Avoid trimming when grass and weeds are wet.
◾
Wire and picket fences can cause extra string wear or breakage. Stone and brick
walls, curbs, and wood may wear strings rapidly.
◾
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can
easily be damaged by the strings.
LINE REPLACEMENT
Please refers to the "LINE REPLACEMENT" section in the manual for EGO kit AH3810
(SOLD SEPARATELY).
38
56-VOLT LITHIUM-ION COMMERCIAL 12" BRUSH CUTTER — BCX4500/BCX4500-FC
Do not remove or alter
12
Publicidad
