4. Maintenance and care of the appliance
4.1 Overall cleaning
Dusts behind the refrigerator and on the ground shall be timely cleaned to
improve the cooling effect and energy saving.
Check the door gasket regularly to make sure there are no debris. Clean the door
gasket with a soft cloth dampened with soapy water or diluted detergent.
The interior of the refrigerator should be cleaned regularly to avoid odor.
Please turn off the power before cleaning interior, remove all foods, drinks, shelves,
drawers, etc.
Use a soft cloth or sponge to clean the inside of the refrigerator, with two
tablespoons of baking soda and a quart of warm water. Then rinse with water and
wipe clean. After cleaning, open the door and let it dry naturally before turning on
the power.
For areas that are difficult to clean in the refrigerator (such as narrow sandwiches,
gaps or corners), it is recommended to wipe them regularly with a soft rag, soft
brush, etc. and when necessary, combined with some auxiliary tools (such as thin
sticks) to ensure no contaminants or bacterial accumulation in these areas.
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause
odors in the interior of the refrigerator or contaminated food.
Clean the bottle frame, shelves and drawers with a soft cloth dampened with
soapy water or diluted detergent. Dry with a soft cloth or dry naturally.
Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy
water, detergent, etc., and then wipe dry.
Do not use hard brushes, clean steel balls, wire brushes,
abrasives (such as toothpastes), organic solvents (such as
alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline
items, which may damage the fridge surface and interior.
Boiling water and organic solvents such as benzene may
deform or damage plastic parts.
Do not rinse directly with water or other liquids during cleaning
to avoid short circuits or affect electrical insulation after
immersion.
Please unplug the refrigerator for defrost and cleaning.)
4.2 Cleaning the glass shelves
Remove the drawer under the glass shelf.
Lift the front of the shelf (about 60°) and pull it
out.
Clean the shelf as necessary.
Follow the same steps in reverse to install the
shelf again.
17
V.1