8.
Pull to remove the filter from the silicone
tube. Place the filter in a container and
fill with enough vinegar to cover the filter.
Soak for 1 hour. [
Figure 7.6
9.
Rinse all parts until any vinegar smell is
completely gone. [
Cleaning the Aroma Pad
Pull out the aroma box and remove the
1.
aroma pad. [
Figure 4.1
2.
Rinse the pad under warm, running
water. [
Figure 8.1
3.
Dry the pad with a clean cloth.
4.
Place the aroma pad back into the aroma
box. [
]
Figure 8.2
Note:
Do not use liquid cleaners or detergents
to clean the pad or any other part of the
humidifier.
Replacing the Aroma Pad
If the aroma pad is stiff even after cleaning,
then it needs to be replaced. Extra pads are
included with the humidifier.
To maintain the performance of your
humidifier, only use official Levoit aroma
pads. For more information, contact
Customer Support (see page 18).
Reassembling
Push the filter back onto the silicone
1.
tube. Place the filter in the water tank.
]
[
Figure 9.1
2.
Replace the mist tube on the water inlet
tank. [
Figure 9.2
3.
Flip the water inlet tank over and replace
the muffler. [
Figure 6.4
4.
Place the water inlet tank in the
humidifier base and replace the top
cover.
]
]
Figure 7.7
]
]
]
]
5.
Place the humidifier base properly on the
water tank.
6.
Refill the tank, if necessary.
Replacing the Remote Control
Battery
1.
Remove the battery compartment by
pinching the tab in and pulling the
compartment out. [
2.
Remove the old battery
3.
Replace with a new 3V CR2025 battery.
Make sure the polarities match.
4.
Replace the battery compartment.
Storing
1.
Follow the cleaning instructions (see
page 12) and allow all parts to dry
completely before storing.
Wrap the power cord around the cable
2.
winder.
3.
Store in a cool, dry location.
]
Figure 10.1
EN
13