Levoit LUH-M101S-WEUR Manual Del Usuario página 7

REMOTE CONTROL
The remote control can be used to control any
of the humidifier's functions from a distance.
The remote must be within 16 ft / 5 m of the
humidifier to work.
Note:
•
Remove the plastic tab from the remote
control's battery compartment before using.
•
To replace the battery, see page 13.
Display Off Button
• Press to turn the humidifier display off.
• Press any button to turn the display
back on.
Humidity Level Button
• Press to set a target humidity level from
40–80% that's used with Auto Mode.
• Continue pressing to cycle through target
humidity options in increments of 10%.
Night Light Button
Press to turn the night light on/off.
•
Timer Button
• Press to cycle through timer options from
1–12 hours.
• Press and hold to quickly cycle through
options in increments of 1 hour.
Note: See inside cover [
Remote Diagram
AN.
On/Off Button
AO.
Auto Mode Button
AP.
Mist Level Button
AQ.
Humidity Level Button
AR.
Display Off Button
AS.
Sleep Mode Button
AT.
Night Light Button
AU.
Timer Button
]
Figure 1
GETTING STARTED
1. Remove all packaging.
2. Flip the water tank over. Use the
screwdriver to attach the stand to the
water tank with the 4 included screws.
[ ]
Figure 2.1
Note: Do not overtighten the screws.
3. Take out the filter from inside the water
tank. Remove the foam around the filter.
4. Place the humidifier base on the water
tank.
5. Optionally, peel off the sticker cover on
the cable winder and attach the cable
winder to the back of the humidifier base.
[ ]
Figure 2.2
6. Choose a hard, flat location for the
humidifier at least 12 inches / 30 cm away
from any walls. The surface must be
water-resistant. [
Figure 2.3
Note: Placing the humidifier away from walls
ensures that the humidity sensor and air inlets
function properly.
7. Mist should be directed away from walls,
furniture, bedding, and appliances.
[ ]. Avoid letting too much mist
Figure 2.4
fall on the side of the humidifier with the
aroma box, as this may interfere with the
sensor inside the aroma box
Filling & Refilling
Note: Make sure the water tank is clean before
filling.
1. Remove the top cover.
2. Use a pitcher or bottle to fill the water
inlet tank with room-temperature water.
You can also add water directly to the
water tank. [
Figure 2.6
EN
]
]
[Figure 2.5
]
7