Connecting The Differential Switch To The Kit - Iberspa 41993E Manual De Instrucciones

Check that the differential switch is in the OFF position. Do not place the differential switch in
the ON position until the Spa is full of water.

2.3.2 Connecting the differential switch to the Kit.

Before doing any work on the kit, the electrical power supply should be switched off (differential
switch in the OFF position, or disconnect the cable from the mains).
Use appropriate cable from the differential switch to the electrical cabinet of the kit, depending
on the type of location where the kit is to be installed, and current applicable law. The cable
section will be different depending on the model of kit and the distance of the installation.
High Amp / Low Amp Configuration.
Depending on the configuration of the kit, the consumption of electricity can vary considerably,
and as a result, the installation should match the electric power required.
LOW AMP:
This configuration disconnects the electric heater when any massage pump is started-up. This
configuration limits the electricity consumption.
NOTE: LOW AMP is the standard default configuration.
A differential
switch must
be installed
OFF ON
GREEN RED
30