Iberspa 41993E Manual De Instrucciones página 32

Bear in mind the position of the maximum consumption Switch.
If you do not use cable suitable for the distance and power of the Kit, it will not work
properly and may cause overheating in the electrical circuits with the risk of an electrical
accident. Always use the cable with a section suitable to maximum consumption. In the
event of doubt between two values, always use the cable with greater section.
To connect the power supply of the Kit, locate the free packing gland at one end of the
Automatic - Manual Selector panel.
Make sure that there is no electrical current in the connection cable (differential switch in the
OFF position).
Take the cable to the panel of the Kit.
Single line (1 x 16 A) LowAmp or (1 x 32 A) HighAmp:
Open the cabinet of the Automatic - Manual Selector, insert the cable through the free packing
gland and connect the Neutral marked with N, the line or phase to the terminal marked L and
the earth in the special, green and yellow, earth terminal.
HIGH AMP / LOW AMP
HIGH AMP: switch A10 should be ON
LOW AMP: switch A10 should be OFF
ATTENTION
32