Cleaning The Pre-Filter Of The Pump; Maintenance In Periods Of Non-Use Or Absence - Iberspa 41993E Manual De Instrucciones

5.2. CLEANING THE PRE-FILTER OF THE PUMP

It is recommended to periodically check the condition of the pre-filter of the pump to avoid it
from blocking. If debris has accumulated, the pre-filter should be opened and cleaned.
Follow these steps to clean the pre-filter:
1. Turn off the Filtering Pump by placing the selector in the OFF position.
2. Close the valve of the filtering circuit that connects the pump to the Spa.
3. Using the key supplied with the equipment, turn the upper cover of the pre-filter
anticlockwise until it becomes loose. Remove the basket of the pre-filter to clean it.
4. Put the basket back into place. Place the joint of the cover to close it using the key.
5. Open the filtering circuit valve.
Please read the pump manual for further information.

5.3. MAINTENANCE IN PERIODS OF NON-USE OR ABSENCE

• Programme the temperature to its lowest level.
• Adjust the pH and treat the water (see the section on Water Maintenance of the Spa
Manual).
• On your return, set the temperature to the required level, readjust the pH and once again
treat the water.
If you do not use the Spa during winter or for prolonged periods of time, the following
operations should be performed:
• Switch off the equipment from the mains.
• Empty the Spa.
• Clean and dry the Spa.
• Cover the Spa, if you have a cover.
Do not leave the Spa with water and disconnected from the mains outdoors in
temperatures lower than 0º, otherwise the pipes could freeze and damage the Spa.
ATTENTION
40