Troubleshooting - Iberspa 41993E Manual De Instrucciones

7. TROUBLESHOOTING

PROBLEMS
Low water level
filtering, Low flow errors in
the control panel.
The massage pump does not
work.
Nothing works.
The air blower massage pump
does not work.
Low air flow.
The water does not reach the
required temperature.
Note: The diagnosis messages to solve possible breakdowns are mentioned in the section
Diagnosis Message of the control panel (Spa User Manual).
CAUSES
during Blocked filter.
The digital control panel cable
is disconnected
board.
Differential switch is off.
The cable of the digital control
panel is disconnected from
the board.
There is no power supply.
The pump has switched off
automatically
overheating.
The motor brushes are worn.
The probe is worn.
Check the
Temperature.
SOLUTIONS
Wash the filter.
Connect
from the board.
Check the connection of the
pump to the electrical panel.
Turn on the differential switch.
Connect
board.
Check the connection of the
pump to the electrical board.
Leave it to cool for approx. 3
owing to hours and switch on the pump
again.
Change the pump.
Change
probe
programmed
Configure the Temperature.
42
the cable to the
the cable to the
the Temperature