Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR
II.
INSTALLATION
2. REMINDERS FOR THE INSTALLER
READ THIS MANUAL CAREFULLY. IT
PROVIDES
INFORMATION
INSTALLATION,
MAINTENANCE OF THE APPLIANCE.
FAILURE TO COMPLY WITH WHAT IS
PRESENTED
COMPROMISE THE SAFETY OF THE
EQUIPMENT.
THE MANUFACTURER WILL NOT BE
LIABLE FOR ANY DAMAGE OR
INJURY RESULTING FROM FAILURE
TO OBSERVING THE FOLLOWING
RULES.
- Identify the specific appliance model. The model
number is detailed on the packing and on the
appliance dataplate.
- The appliance must be installed in a well-ventilated
room.
- Installation and conversion to a different type of
gas must be carried out by qualified technicians
authorized by the manufacturer, in compliance
with current safety standards and the instructions
in this manual.
- Appliance maintenance and conversion to a
different type of gas must be carried out by
qualified
technicians
manufacturer, in compliance with current safety
standards and the instructions in this manual.
- Do not obstruct any air vents or drains present on
the appliance.
- Do not tamper with appliance components.
3. REFERENCE STANDARDS AND LAWS
- Install the appliance in accordance with the safety
standards in force in the country.
4. UNPACKING
- Check the state of the packing and in the event of
damage, ask the delivery person to inspect the
goods.
IMPORTANT
FOR
SAFE
USE
AND
BELOW
MAY
authorized
by
the
- Remove the packing.
- Remove the protective film from the outer
panels.Use a suitable solvent to remove any
residual adhesive from the panels.
5. POSITIONING
- The overall dimensions of the appliance and the
position of connections are given on the installation
diagram at the end of this manual.
- The appliance can be installed singly or in
combination with other appliances in the same
product range.
- The appliance is not suitable for integrated
installation.
- Position the appliance at least 10 cm from adjacent
walls. This distance can be reduced in the presence
of non-combustible walls or heat-insulated walls.
- Level the appliance by means of the height-
adjustable feet
APPLIANCE ASSEMBLY WITH BASE, BRIDGE AND
CANTILEVER SOLUTIONS
Follow the instructions provided with the type of
support utilized.
FIXING THE APPLIANCE TO THE FLOOR
Secure the appliance to the floor one by one using
the adjustable feet, flanged.
JOINING APPLIANCES TOGETHER IN LINE
Remove the control panels . (A)
Remove the fixing screw nearest the panel from
each of the sides to be joined. (B)
Place the appliances side by side and adjust the
tops to the same height. (C)
Insert the (supplied) connector platein the seat
provided on the side of the top.Join the appliances
by screwing down the connector plate using the
the flat-headed M5 screws (supplied). (D)
Turn one of the two internal tabs of the appliances
to be joined by 180°. (E)
Join the appliances by screwing the M5x40 screw
on the opposite insert . (E)
FUMES EXHAUST SYSTEM
Create a fumes exhaust system based on the
"Type" of appliance. The "Type" is stated on the
appliance dataplate.
"A1" TYPE APPLIANCE
17
Publicidad
