Publicidad
Idiomas disponibles
Idiomas disponibles
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Igniter defective or not properly connected.
- Igniter or igniter wire defective.
Pilot burner goes out during use
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
- Knob of gas tap or valve not pressed a.
The main burner does not light (even though pilot
is lit)
Possible causes:
- Defective burner (gas outlet holes clogged).
20. REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE
OFF
AT
INSTALLED UPSTREAM.
DISCONNECT
ELECTRIC
BEFORE
OPERATION.
AFTER REPLACING A GAS SYSTEM
COMPONENT,
LEAKS AT CONNECTION POINTS.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS GRILL
Replacing the gas tap.
Remove the control knob.
Remove the bottom front panel.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
Replacing the burner, the pilot burner and the
THE
MAIN
SWITCH
THE
APPLIANCE
SUPPLY,
IF
PRESENT,
CARRYING
OUT
ANY
CHECK
FOR
GAS
thermocouple.
Remove the grease collection drawer.
Remove the control panel.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
Replacing the main burner.
Remove the grease collection drawer.
Remove the control knob.
Remove the bottom front panel.
Remove the control panel.
Remove the splashguard, the grilles, the tiles, the
front tile support and the burner guard.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC GRILL
Replacing the knob and indicator light
Remove the grease collection drawer.
Remove the control knob.
Remove the bottom front panel.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
Replacing the element.
Remove the grease collection drawer.
Remove the control panel.
Remove the splashguard and the grille.
Remove the box and the cover of the element
terminals by unscrewing the self-tapping screws
from the top of the appliance.
Remove the component from above and replace it.
Reassemble all parts. For assembly, proceed in
reverse order.
Replacing the working thermostat.
Remove the grease collection drawer.
Remove the control knob.
Remove the bottom control panel.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
GAS LAVA STONE GRILL
Replacing the gas tap.
24
Publicidad
