Publicidad
Idiomas disponibles
Idiomas disponibles
Making Angular Cuts
Angular cuts must always be made using the rip fence.
1. Set the blade to the desired angle.
2. Set the rip fence in accordance with the workpiece width and height.
3. Carry out the cut in accordance with the workpiece width.
Making Cross Cuts
1. Press the workpiece firmly against the miter gauge.
2. Switch on the saw.
3. Push the miter gauge and the workpiece toward the blade in order to make the cut.
Warning! Always hold the guided part of the workpiece. Never hold the part which is to be cut off.
4. Push the miter gauge forward until the workpiece is cut all the way through.
5. Switch off the saw. Do not remove the offcut until the blade has stopped rotating.
3.4.3.
Transport
1. Turn off the power tool before any transport and disconnect it from the power supply.
2. Apply the power tool at least with two people, do not touch the table extensions.
3. Protect the power tool from knocks, bumps and strong vibrations such as during transport in vehicles.
4. Secure the power tool against overturning and sliding
5. Never use the safety devices for handling or transporting purpose.
3.5.
Cleaning and maintenance
Warning! Prior to any adjustment, maintenance or service work disconnect the mains power plug!
General Maintenance Measures
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the
equipment with a clean cloth or blow it with compressed air at low pressure.
We recommend that you clean the device immediately each time you have finished using it.
Clean the equipment regularly with a damp cloth and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the
device. The ingress of water into an electric tool increases the risk of an electric shock.
In order to extend the service life of the tool, oil the rotary parts once monthly. Do not oil the motor.
Saw Blade Change
1. Ensure that the table saw is not connected to the mains supply.
2. Use protective gloves. Do not touch the saw blade with your bare hands.
3. Make sure that the saw blade has been lowered all the way into the saw table. If necessary, lower the
saw blade by turning the crank counterclockwise up to the stop point.
4. Remove the saw blade guard from the riving knife. Gently pulling the saw blade guard apart. See
below illustration 1.
5. Loosen the four screws from bench insert and remove the bench insert.
Always check the bench insert in the process: Immediately replace the bench insert if it is
damaged or is no longer flush with the saw table.
6. Make sure that the angle of the saw blade is set to 0°.
7. Rotate the saw blade all the way out of the saw table by turning the crank clockwise up to the stop
point.
EN
Publicidad
