Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
FM Tuner Section
Tuning range
Antenna
87.5 MHz-108 MHz
300 ohm
balanced
75 ohm
unbalanced
Intermediate frequency 10.7 MHz
Sensitivity at 46 dB quieting (40 kHz deviation)
4.0 #V (MONO)
50 #V (STEREO)
1.7 uV, S/N=26 dB (40 kHz deviation)
1.9 #V, 10.7 dBf ; IHF
Signal-to-noise ratio
75 dB (MONO)
70 dB (STEREO)
at 100 Hz
0.15% (MONO)
0.25% (STEREO)
at
1kHz
0.15% (MONO)
0.25% (STEREO)
at 10 kHz
0.2% (MONO)
0.5% (STEREO)
Usable sensitivity
Harmonic
distortion
IM distortion
0.15% (MONO)
0.25% (STEREO)
Separation
35 dB at 100 Hz
45 dB at 1kHz
40 dB at 10 kHz
+0.5
30 Hz-15 kHz *9°2 dB
40 Hz-12.5 kHz *9-8 aB
40 dB at 300 kHz
60 dB at 400 kHz
Capture ratio
1.0 dB
AM suppression ratio
54 dB
Image response ratio 80 dB
IF response
ratio
100 dB
Spurious response
ratio
90 dB
RF intermodulation
60dB
Output level/impedance
450 mV, 6.8 kilohm at
1kHz deviation,
100%
modulation
Frequency response
Selectivity
AM
Tuner Section
Tuning range
Antenna
530 kHz-1,605 kHz
Attached AM antenna wire
External antenna terminal
Intermediate frequency
European
and UK models:
468 kHz
Canadian and other country models:
455 kHz
100 #V, external antenna
at 1,000 kHz
Signal-to-noise ratio
52 dB at 5mV
Harmonic
distortion
0.3% at
5 mV, 400 Hz
Usable sensitivity
Selectivity
28 dB at 9 kHz
30 dB at 10 kHz
General
System
FM stereo, FM/AM
superheterodyne tuner
Power requirements
Canadian
model:
120V ac, 60 Hz.
UK model:
240V ac, 50 Hz.
European
and
other country
models:
120,
220, or 240V ac adjustable,
50/60 Hz.
Canadian
model:
20W
European,
UK
and
other
country
models:
24W
Power consumption
Dimensions
Approx. 410 x 145 x 260 mm
(w/h/d)
(16 1/4 x 5 3/4 x 10 1/4 inches)
incl. projecting parts and controls
Approx.
5.7 kg (12 Ib 9 oz) net
6.7 kg (14 Ib 12 oz) in shipping
carton
FM ribbon antenna
Weight
Accessory supplied
While the information given is true at the time
of printing,
small
production changes in the course
of our company's policy of im-
provement through research, and design might not necessarily be
indicated in the specifications.
We would ask you to check
with
your appointed Sony dealer if clarification on any point is required.
TROUBLE
CHECKS
.
The
following
chart will help correct most problems which may
occur with the unit.
If the problem persists after you have made
these checks, consult your Sony dealer.
Before
going through
the
check list of specified troubles below,
first refer back to the connections
on
page
3 and the operating
procedures on page 6.
No audio output
e Depress the POWER
switch.
Note if the Dial lights.
e Check that the power cord is plugged into a working outlet.
e Check the connections to the amplifier.
e Check the setting of the amplifier's input selector, volume con-
trol and power switch.
SIGNAL indicator reading is unstable.
e Adjust the antenna.
STEREO
lamp does not light when receiving stereo programs.
e Adjust the antenna.
e Check that the MODE
selector is at STEREO.
STEREO
lamp flickers.
e Set the MODE
selector to MONO.
elf the
SIGNAL
indicator
shows
weak
antenna
input,
use
an
appropriate
outdoor
antenna.
A multi-element
type
is recom-
mended.
elf the indicator shows sufficient level but an unstable reading,
adjust the antenna to eliminate multipath reception.
Severe hum or noise.
e Tune accurately.
e Ground the tuner.
e Avoid long horizontal runs of antenna lead.
e Keep connecting cords (or antenna lead-in) away from transfor-
mers or motors, and at least 3 meters (10 feet) from TV sets and
fluorescent lights.
e Adjust the antenna.
Ignition noise.
e Tune accurately.
e Install the outdoor antenna away from heavy traffic.
eUse a shielded or coaxial lead-in for the antenna.
Electrostatic charge
e Ground the tuner.
Tuning cannot be made with Program Sensor System.
e Check that the PROGRAM
SENSOR
button is depressed.
eCheck that the Station Marker is preset correctly.
eAdjust
the antenna.
If the input signal is insufficient, tune in
the station without the Program Sensor System.
Publicidad
