Publicidad
Do not exceed the lifting handle's safe working load of 75kg (165 lbs.)
Do not exceed the straight bar with clamp's safe working load of 20kg (44
lbs.)
If a serious incident occurs in relation to this medical device, affecting the user, or
the patient then the user or patient should report the serious incident to the medical
device manufacturer or the distributor. In the European Union, the user should also
report the serious incident to the Competent Authority in the member state where
they are located.
Installation (8 steps)
1. To install screw clamps or pulley clamps: fully undo the screw and open the clamp.
Position the clamp around the fracture frame. Close the clamp and rotate the knob (Fig.
1a) to lock the clamp together and tighten the screw (Fig. 1b).
1a
2. Lower the bed to minimum height and apply the brakes. Use the ACP to disable the bed
controls - refer to the bed instructions for use.
3. Fit the head end bow A into the accessory sockets at the head end of the bed, with the bow
angled in towards the bed (Fig. 2).
2
WARNING
A
1b
EN
Publicidad
