cecotec Cumbia CREMMAET COMPACT STEAM Manual De Instrucciones página 24

ENGLISH
After frothing the milk, always
immerse the steamer in a cup
of clean water. Follow the
same milk frothing process to
clean the steamer. Then dry
Steamer the steamer with a cloth and
keep it clean.
Remove and rinse the steamer
periodically in case of daily
use.
Remove the drip tray and the
waste container, rinse them
Drip tray
under running water and wipe
and waste
them with a cloth.
container
Clean them at least every two
days.
Rinse the tank under running
water every 3 days.
Water tank
Empty it if you are not going to
use it for a long time.
Clean the coffee bean
container weekly. Use a soft,
dry cloth to wipe oil/coffee
grounds from the inside.
Coffee bean If there is too much oil inside
container/ the bean container, it is
grinder possible that there is too much
oil in the grinder.
Clean the grinder thoroughly in
case of grinding problems.
Open the right panel, remove
the brewing unit and clean the
Ground coffee
ground coffee channel with a
groove
soft cloth on a weekly basis.
Dismantling parts for cleaning
Fig. 15
1. Pull the water tank upwards and remove it.
46 CREMMAET COMPACT STEAM
You can use liquid or cleaning tablets to
remove milk residue.
To clean the bean container and the
grinder, you can use a grinder cleaner for
coffee machines: place the cleaner inside
the container and prepare an espresso
with the maximum amount of coffee.
Then, clean the container by hand.
2. Pull the right panel outwards.
3. Press where the blue arrow in figure 15 indicates and remove the processing unit.
4. Lift the drip tray slightly and remove it.
Fig. 16
1. Replace the water tank in the coffee machine.
2. Push the processing unit along the groove until a snapping noise is heard, as shown in
figure 16.
3. Push the drip tray inwards into place.
Warning:
- When reinstalling the processor unit, a snapping noise will be heard; if you do not hear it,
disassemble the processor unit again and reinsert it.
- Make sure that the water tank is fully inserted. If this is not the case, push the water tank
down until it clicks into place.
6. TROUBLESHOOTING
In the event of a fall or malfunction, unplug the appliance immediately from the mains socket.
If a mechanical failure occurs in the appliance, please contact your supplier, authorised dealer
for repair or the official Cecotec Service Centre.
Num Problem Num Possible cause
1 The control 1.1 Water tank is out of
panel display water.
shows
the water
tank icon.
The display 2.1 The water tank is not
2 shows correctly installed.
"continuous
2.2 No pasa agua por la
square line",
bomba.
press the
2.3 The internal piping is
Settings/Exit
blocked.
button but
the coffee
machine
does not
dispense
water.
ENGLISH
Solution
Fill the water tank and install it in
the appliance.
Install the tank securely inside
the coffee machine.
Contact the official Cecotec
Technical Support Service.
Contact the official Cecotec
Technical Support Service.
CREMMAET COMPACT STEAM 47