Publicidad
Idiomas disponibles
Idiomas disponibles
lectrical Requirement
For E
Review the following options to determine the appropriate electrical
connection for your home:
Use the instructions
hi this section :if your home has
a 4-wire receptacle
(NEMA
type 14-30R) and you
will be using a UL listed, 120/240 volt minimum,.
30 amp, dryer power supply cord.
Ise the instructions
in this section if your home has
a 3-wire receptacle
(NEMA
type 10=30R) and you
will t_e using a IL listed., 120/240 volt n_ininmm,
3(i) amp, dryer power supply cord.
Important
: Grounding through the neutral conductor
is p¢ohiNted tor(l)
new brm_ch-circuit installations,
(2)
mobile homes, and (3) recreational
vehicles, and (4)
areas where local codes prohibit grounding through the
neutral conductor.
Prepare minimum 5ft (1.52m) of length in order for
dryer to _ :replaced.
First, peel 5 inches (12.7cm) of covering material from
end. Strip 5 inches of ground wire insulation. After cutting
1"/2inch (3.8cm) t_3m 3 other wi_s peel insulation back
linch (2.5cm). Make ends of 3 wires a hook sha_.
,¢
If this type is available
at your home. you will k,e
connecting
to a :tused discolmect
or circuit breaker
box
It' this type is available
at your home. you will
connecting
to a Oa_d disconnect
or circuit breaker
t_x
• Screw powersupplywire to the terminalbl_
Coloredwire shouldhe conn_ed to samecolor
screw.Wire colorindicatedonmanualis
connectedto thesame colorscrew in block.
Othe_ise, excessivecurrentis appliedresulting
in damageson productand heatingfailure.
• [)irect-wi re connections _ not meet the
building coderegulationsin most areas. It is the
customer'sresponsibility to ensurethat the
installationmeets all suchrequirements.
Then, put the h_ked shape end of the wire under the
screw of the mnninal bl_k (h_ked
end facing rightward)
and pinch the hook together and screw tightly.
1. Connect neutral wi_ (white) of power cord to center
terminal block screw.
2. Connect red and black wire to the left and right
terminal bl_k
screws.
3. Connect ground wire }green) of power cord to
external ground screx_ and the move neutral ground
,_,:ireof a}pliance and connect it to center scow.
4. Make sure that the strain relief screw is tightened.
and be sure that N1 terminN block imts are on tight
and power cord is in right position.
C_r
terminal Nook
scr_
Neutral grounding
NeL_r_l wire
(white Orcenter _)
Green wire of _
_d
_re_
Publicidad
