Publicidad
Idiomas disponibles
Idiomas disponibles
uirement
For E
c D
Following
are additional
instructions
regarding
electrical
c_mnections
and. requirements
ti_r electtic dryers.
Impo_ant
Warning:
"I_ help prevent fire, electric shock, serious i1_ury or death, the wiring and grounding
must conform
to the latest edition of the National
Electrical
Code, ANS|/NFPA
70 and all applicable
local
regulations.
Please contact a qualified
electrician
to check your home's
witing and fuses to ensure that your home
has adequate electrical
power m operate the &yer.
120V/240V,.
60 Hertz,. 3-Wire Installation
Instructions
for Grounding
of your Electric
a) This dryer must be com_ected, to a grounded
metal,, permanent
wiring system or an
equipment-grounding
conductor
must be run
with the circuit conductors
and connected
to the
equipment-grounding
tem_inal or lead on the
dryer.
b) The dryer has its own terminal block that must
t_ connected
to a separate 60 Hertz single
phase AC circuit,
fused at 30 Am_res
(the
circuit must be fused on tx)th sides of the line).
ELECTRICAL
SERV|CE
FOR THE DRYER
SHOI ,ILl) BE OF MAXIM1 M RATE
VOIJ|"AGE
I_ISTEI) ON THE NAMEPLATE.
DO NOT ('.()NNE(rF
DRYER TO 110. 115,
OR 120 VO/;/' CIRCUrll
Heatil g elements
are
available
lor field installation
in drym> which
are to _ connected
to electrical
service of
different volta ge than that listed on nameplate.
c) If branch circuit to dryer :is :fifteen tiaet (4.50 m)
o:r less in length, use [.L.
(Underwriters
/,aboratories)
listed No. 10 A.W.G. wire (copper
wire only), or as required by local codes. If over
|ifteen
liaet (4.50 m), use ILL. (Underwriters
Lat_)ratories)
listed. No. 8 A.W.(L wire (copper
wire only),, or as required by local codes. Allow
sul]'icient
slack in wiring so dryer can t-_ e moved
|rom its normal location
when necessary.
d)
e)
0
The lx_wer cord (pigtail) connection
between
wall receptacle
and dryer terminal
block IS NOT
supplied
with dryer. Type of pigtail and gauge of
wire nmst cont_.mn to local codes and with
insmactions
mentioned
on the |k_llowing pages.
'/11e method of wiring the dryer :isoptional
arid
subject to local code requirements.
Refer to
examples
on next page.
You must select the method by which to wire
your dryer according
m local code and ordinance
:requirements.
Sample methods
are included in
the |k_llowing pages,
Label all wires prior to disconnection
When
servicing
the dryer, because
wiring errors can
cause serious
injury to you and your dryer.
Publicidad
