Publicidad
Idiomas disponibles
Idiomas disponibles
TO OPERATE
MOWER
Your tractor
is equipped
with an operator
presence
sensing
switch.
Any attempt
by the operator
to leave the seat with the
engine
running
and the attachment
clutch
engaged
will shut off the engine.You
must
remain fully and centrally
positioned
in the
seat to prevent the engine from hesitating
or cutting
off when operating
your equip-
ment on rough, rolling terrain or hills.
I.
Select desired
height of cut with at-
tachment
lift lever.
2o Start mower blades
by engaging
at-
tachment
clutch
control.
TO STOP MOWER
BLADES
-
disengage
attachment
clutch control.
• b, C AUTION:
Do not operate
the mower
without
either the entire grass catcher,
on mowers
so equipped,
or the deflector
shield
(S)in
place°
REVERSE
OPERATION
SYSTEM (ROS)
Your tractor
is equipped
with a Reverse
Operation
System
(ROS)° Any attempt
by
the operator
to travel in the reverse direc-
tion with the attachment
clutch engaged
wilt shut off the engine unless
ignition
key
is placed
in the ROS "ON" position.
_WARNING:
Backing
up with the at-
tachment
clutch engaged
while mowing
is strongly
discouraged°
_Jrning
the ROS
"ON", to allow reverse operation
with the
attachment
clutch engaged,
should
only
be done when the operator
decides
it is
necessary
to reposition
the machine
with
the attachment
engaged,
Do not mow in
reverse
unless
absolutely
necessary.
USING THE REVERSE
OPERATION
SYSTEM
-
Only use if you are certain
no children
or
other bystanders
will enter the mowing
area,
1, Move motion control
lever to neutral
(N) position.
2,
With engine running,
turn ignition
key
counterclockwise
to ROS "ON" posi-
tion,
3.
Look down and behind
before and
while backing.
4.
Slowly move motion control
lever to
reverse (R) position
to start movement,
5.
When use of the ROS is no longer
needed,
turn the ignition key clockwise
to engine
"ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
'TO OPERATE
ON HILLS
,_WARNING:
Do not drive up or down
hills with slopes
greater than 15 ° and do
not drive across
any slope, Use the slope
guide provided
at the back of this manual
o Choose
the slowest
speed
before start-
ing up or down hills.
• Avoid stopping
or changing
speed on
hills.
° If stopping
is absolutely
necessary,
push
clutch/brake
pedal quickly
to brake posi-
tion and engage
parking
brake.
° Move motion
control
lever to neutral
(N)
position.
IMPORTANT:
The motion control
lever
does not return to neutral
(N) position
when the clutch/brake
pedal is depressed.
.
To restart movement,
slowly release
parking
brake and clutch/brake
pedal.
° Slowly move motion control
lever to
slowest setting.
.
Make all turns slowly.
TO TRANSPORT
When
pushing
or towing your tractor,
be
sure to disengage
transmission
by placing
freewheel
control
in freewheeling
position,
Freewheel
control
is located at the rear
drawbar
of tractor°
I.
Raise attachment
lift lever to its highest
position.
2.
Pull freewheel
control out and into the
slot and release
so it is held in the
disengaged
position.
° Do not push or tow tractor at more than
two (2) MPH.
° To re-engage
transmission,
reverse
above procedure.
Transmission
Engaged
12
Transmission
Disengaged
Publicidad
