Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to s service center
:_ROBLEM
CAUSE
CORRECTION
1, Remove
obstruction.
Mower blades will
not rotate
Poor grass
discharge
Headlight(s)
not
:working
(if so equipped)
Battery
will not
charge
Loss of drive
Engine
"backfires"
when
turning
engine
"OFF"
1. Obstruction
in clutch
mechanism.
2.
Worn/damaged
mower drive
belt.
3.
Frozen idler pulley.
4.
Frozen blade mandrel.
5.
Mower belt off engine pulley.
1.
Engine speed too slow.
2. Travel speed too fast.
3o Wet grass.
4,
Mower not level.
5.
Low/uneven
tire air pressure°
6. Worn, bent or loose blade.
7.
Buildup
of grass, leaves and
trash under mower.
8.
Mower drive belt worn.
9.
Blades
improperly
installed.
10. Improper
blades
used.
1t. Clogged
mower vent
holes from buildup
of grass,
leaves,
and trash around
mandrels.
1.
Light switch is "OFF".
2.
Bulb(s) or lamp(s) burned out.
3o Faulty light switch.
4.
Loose or damaged
wiring°
5o Blown fuse.
t.
Bad battery
cell(s).
2,
Poor cable connections,
3.
Faulty regulator
(if so equipped).
4.
Faulty alternator.
1o Freewheel
control in
"disengaged"
position.
2.
Motion drive belt worn,
damaged,
or broken°
3. Air trapped
in transmission
during shipment
or servicing.
Engine throttle
control not set
between
half and full speed
(fast) position
before stopping
engine.
2_
4.
.
Replace
mower
drive belt.
Replace
idler pulley.
Contact
a qualified
service
center.
Install belt on engine pulley,
1.
Place throttle
control
in
"FAST" position.
2,
Shift to slower speed.
3. Allow grass to dry before
mowing.
4,
Level mower.
5o Check tires for proper air
pressure.
6.
Replace/sharpen
blade.
Tighten
blade bolt.
7,
Clean underside
of mower
housing.
8.
Replace
mower drive belt,
9.
Reinstall
blades sharp edge
down.
I0_ Replace
with blades
listed
in this manual,
11 .Clean
around
mandrels
to
open vent holes.
1. Turn light switch "ON".
2.
Replace
bulb(s) or lamp(s).
3,
Check/replace
light switch,
4.
Check wiring and connections.
5.
Replace
fuse.
1.
Replace
battery,
2.
Check/clean
all connections.
3o Replace
regulator,,
4.
Replace
alternator.
1_ Place freewheel
control in
"engaged"
position
2.
Replace
motion drive belt.
3.
Purge transmission_
!1.
Move throttle
control
between
half and full speed
(fast) position
before
stopping
engine.
3O
Publicidad
