Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACINGBATTERY
d_,WARNING:Do not short battery
terminalsby allowinga wrenchor any
otherobjectto contactbothterminalsat
time sametime.Beforeconnectingbattery,
removemetalbracelets,wristwatchbands,
rings,etc.
Positiveterminalmustbe connected
first to preventsparkingfrom accidental
grounding.
1, Lift hoodto raisedposition.
2. DisconnectBLACKbattery cable (A)
then REDbatterycableand carefully
removebatteryfromtractor.
3, Installnewbatterywith terminalsin
samepositionas old battery.
4, FirstconnectRED batterycable (B)to
positive(+)batteryterminalwith hex
bolt and kepsnut as shown_ Tighten
securely.Slideterminalcover(C) over
terminal_
5o ConnectBLACKgroundingcableto
negative(-) batteryterminalwith re-
maininghex boltand kepsnut.Tighten
securely
6. Close hood.
_
Negative
(Black)
Cable
p,"
Positive
(Red)
Cable
TO REPLACE
HEADLIGHT
BULB
1. Raise hood°
2.
Remove
bulb holder from the hole in
the backside
of the grill.
3.
Replace
bulb in holder and install bulb
holder securely
back into the hole in
the backside
of the grill.
4.
Close hood.
INTERLOCKS
AND RELAYS
Loose or damaged
wiring
may cause
your tractor to run poorly, stop running,
or
prevent it from starting,
• Check wiring.
See electrical
wiring
diagram
in the Repair
Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-in fuse.
The fuse holder is located
behind the dash.
TO REMOVE
HOOD AND GRILL
AS-
SEMBLY
1.
Raise hood°
2.
Unsnap
headlight
wire connector.
3.
Stand in front of tractor.
Grasp
hood at
sides, tilt toward engine
and lift off of
tractor.
4_ When replacing
hood, be sure to re-
connect
the headlight
wire connector.
Hood
Headlight Wire
Connector
ENGINE
TO ADJUST
THROTTLE
CONTROL
CABLE
The throttle
control has been preset at
the factory
and adjustment
should
not be
necessary
Check adjustment
as described
below before loosening
cable. If adjust-
ment is necessary,
see engine
manual.
TO ADJUST
CHOKE
CONTROL
The choke control
has been preset at
the factory
and adjustment
should
not be
necessary.
If adjustment
is necessary,
see
engine
manual.
ADJUST
CARBURETOR
Your carburetor
has been preset at the
factory
and adjustment
should
not be nec-
essary. However,
minor adjustment
may
be required
to compensate
for differences
in fuel, temperature,
altitude or toad _ If the
engine
does need adjustment,
see engine
manual.
26
Publicidad
