Section 4: Operation
[. Start engine according to [nstrucdons
given in engine
owner's manuaLA[so see operating instructions
tag
located on the pressure washer.
_
CAUTION
. When
starring engine, punt cord slowiy und[ resistance is fek
and then pull rapidly to avoid kickback.
ff engine starts and fails to continue
to run or if increased
resistance is fek during starting pull attempts, squeeze trigger
on spray gun.
Now to Stop Your Pressure
Washer
o Move variable pressure control
lever to "Stop"
position.
o Turn engine off according to instructions
given in the
engineowner's manual
o Squeeze
trigger on the spray gun to relieve
pressure in the hose°
NOTE:
A small amount of water wilt squirt out when you
release the pressure.
Now to Use Accessory
Tray
The unit is equipped with an accessory tray with places to
store your nozzle extensiom turbo nozzle and utility brush_
and slots to hold the cleaning solution
bottle and the
detergent
siphoning filter.There
are also two hooks at the
ends of the handle to hold your spray gun and high
pressure hose.
I.
Place nozzle extension through hole on accessory tray,
as shown in Figure 14.
2.
Hang chemical solution botde on "J" hook and place
detergent siphoning fiker in last slot on [eft (Figure [4).
3.
Place utility brush in the second to last slot on right in
tray (Figure 14).
4.
Place turbo nozzle through hole on accessory tray, as
shown in Figure 14.
5.
Place spray gun on hook attached to accessory tray on
right side of unit (Figure 14).
6.
Hang high pressure hose on hook attached to accessory
tray on left side of unit, as shown in Figure 14.
Now
to Use SprayTips
The quick-connect
on the nozzle extension allows you to
switch between four different spray rips.The spray tips vary
the spray pattern as shown below (Figure [ 5).
CAUTION
NEVER exchange spray tips without
Hocking the safety latch
on the triggen
Follow
these
instructions
to change spray dps:
Engage safety latch on spray gun.
Low
Pressure
Bhck
Use to apply
chemical
40 ° White
15° Yellow
0 ° Red