Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
4.
Phce smallflHter end of detergentsiphoning tube into
detergentcontainer.
• When
inserting the filter into a detergent
solution
bottle,
route the tube so as to keep it from inadvertendy
contacting
the hot muffler_
5.
Hake sure bHack spray tip is installed.
NOTE:
Detergent
cannot be appHied with the high
pressure spray tips (White,Ydlow,
or Red).
6.
Hake sure garden hose is connected to water inlet.
Check that high pressure hose is connected to spray
gun and pump and start engine.
7.
Apply detergent to a dry surface, starting at lower
portion
of area to be washed and work upward_ using
Iong_ evem overlapping
strokes.
8.
Allow detergent to soak in between 3-5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. DO NOT allow detergent
to dry on (prevents streaking).
mNPORTANT:You
must flush the chemical iniection
system after each use by placing the filter into a bud<et of
clean waten then run the pressure washer in low pressure
for 1:2 minutes.
Pressure
Washer
Rinsing
Wash and Rinse Surface
This pressure washer permits regulation of output water
pressure by varying the engine speed.The variable pressure
control
lever found on the front of the engine may be set_
as shown in Figure 19:
Pressure
Low
to
High
Dut 7
Light
Medium
Heavy
Auto
Concrete
Paint removal
Boat
Driveway
Degreasing
Furniture Deck
After
you have applied
detergent,
scour the surface
and rinse
it dean
as fommows:
I.
Apply safety latch to spray gun.
2.
Remove black chemical nozzle from nozzle extension.
3.
Select and install desired high pressure nozzle
following
instructions
"How to Use SprayTips"
on
page I0.
4.
Keep spray gun a safe distance
from the area you plan
to spray.
WARNING
Keep spray nozzle between 8 to 24 inches away from cleaning
SU Place,
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure washer from
a ladden scaffolding or any other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid iniury if gun kicks back.
5.
Adiust spray pressure by sliding variable pressure contol
lever left or right, as shown in Figure 13 on page 9.
6.
Apply a high pressure spray to a small area and then
check the surface for damage. If no damage is found,
you can assume it is okay to continue
rinsing.
7.
Start at top of area to be rinsed, working
down with
same overlapping strokes as you used for cleaning.
Automatic
Cool Down
System
(Thermal
Remief)
If you run the engine on your pressure washer for
3=5 minutes without
pressing the trigger on the spray gum
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging
the warm
water
onto the ground_
Publicidad
