Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
PREPARmNG THE
fJNmT
FOP, STORAGE
VVater shouHd not remain in the unit for Hongperiods of
time. Sediments or mineraHs can deposit on pump parts and
"freeze" pump action. If you do not pHanto use the pressure
washer for more than 30 days_foHHowthis procedure:
H. Rush detergent siphoning tube by pHadng the fiker into
a paiHof dean water wile
running pressure washer in
How pressure mode. Hush for one to two minutes.
2,
Shut off the engine and Herit cool then remove high
pressure and garden hoses. Disconnect
spark pHugwire
from sparkpHug.
3.
Empty the pump of Hiquids by puHHing the engine recoiH
handHe about 6 times.This
shouHd remove most of the
Hiquid in the pump.
4.
Use pump saver to prevent corrosion
buiHd up and
freezing of pump.
5.
Store unit in a cHean_ dry area.
Protecting
the
Pump
To protect
the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and Hubricates pistons and seaHs.
NOTE:
PumpSaver is available as an optionaH accessory. [t
is not incHuded with the pressure washer. Contact the
nearest authorized service center or visit your HocaH Lowe's
store to purchase PumpSaver.
• Failure to do so will permanently
damage your pump and
render your unit inoperable,
Freeze damage is not covered under warranty.
CAUTION
Always wear eye protection when using PumpSave_:
To use PumpSaver, make sure the pressure washer is
turned off and disconnected
from suppHy water. Read and
follow aHH instructions
and warnings given on the PumpSaver
container_
NOTE:
PumpSaver wiHH drip from pump after treatment
and will stain wood and concrete,
NOTE:
If PumpSaver is not avaiHabHe, draw RV antifreeze
(non-aHcohoH) into the pump by pouring the soHution into a
3°foot section of garden hose connected to inlet adapter
and puHHing recoiH handHe twice.
STORING
THE ENGINE
See the engine
owner's
manual
for instructions
on how
to
proper[),
prepare
the engine
for storage,
Publicidad
