Dual 1216 Instrucciones De Manejo página 10

When you move the operating switch to
art". the first record will drop and the
tonearm will lift, move 10 the record, then
descend, If you wish to reject a record
that is playing and move on to the next
move the operating switch once again to
"start".
Fig. 11
Note: Records that have been played can
be lifted back up the spindle for repeat
plays, or removed altogether
need to remove the spindle in either case,
There i s no
The 45 rpm record spindle AS 12 is avai
lable from audio
jeale
Automatic play without
interruption
Fig, 12
Once the record has been laid down on the
platter, insert the puck through the multiple-
play spindle. It is recommended to place a
45 rpm record on top of the puck for added
weight, The record will then play continu
ously without interruption
10
5 as an accessory,
Technical specifications
Cartridge (pick-up)
The following instructions apply only if your
unit was purchased without a cartridge installed,
or if you wish to renlace the cartridge supplied
with one of your own choosing
Fig. 13
1. Release the cartridge holder from the tone.
arm head by pressing the tonearm lift a short
turn to the rear, Be ready to catch the holder,
as it will drop right into your hand
2. Using the necessary spacers, screws and
nuts supplied, mount the cartridge into the
holder, The special gauge supplied will help
you place the cartridge at the geometrically
correct point
The novel snap-on mounting of the Dual
pick-up cartridges on the cartridge holder
eliminates all other forms of mounting, The
snap-on mounting secures perfect geometrical
alignment of the stylus tip.
3. Connect each lead on the cartridge holder
to its corresponding pin on the cartridge.
Each lead is color-coded as shown in fig. 1
0
4. Replace the cartridge holder by placing it
against the tonearm head and
pressing the tonearm lift forward
eft channel (white)
L left ground (blue) 7
AE]
L right ground (green) sd
The turntable will accept any cartridge that
hs from 1 to 8 grams and has standard
* mounting centers,
For information, please contact your dealer.
Balancing the tonearm
The
meat is (bala ed by rotating the
weight
1, Set the stylus force dial to
2. Unlock the tonearm, and lift i t off the
rest. Mave the tonearm just to the inside of
the resting post and turn the tonearm coun
terbalance until the tonearm floats in hori
zontal position
Turning the
the tonearm h
the tonearm
ght counterclockwise rais
ad, turning it c ck wise lower
Fig. 16
The tonearm is precisely balanced when
edge "A" of the tonearm head and edge
"B of the tonearm rest are at equal height
(Fig. 17) or when the tonearm returns by
itself to a horizontal position after the
chassis is tapped.
Precise balance is especially important with
cartridges that require a low stylus force
The balancing operation need be done only
once, unless you install a different cartridge,