Electrical Connection
I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR
ELECTRICAL SHOCK.
1.
Disconnect power.
2. Locate terminal box inside of the hood insert.
A
B
C
D
A.White wires
B. Black wires
C. UL listed wire connectors
D. Green, bare or yellow/green wires
3. Use UL listed wire connectors and connect black wires
(B) together.
4. Use UL listed wire connectors and connect white wires
(A) together.
I WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW
GROUND WIRE IN TERMINAL BOX. FAILURE TO DO SO CAN
RESULT IN DEATH OR ELECTRICAL SHOCK.
5. Connect green (or bare) ground wire from home power
supply to the green/yellow ground wire (D) in terminal
box using UL listed wire connectors.
6. Install terminal box cover.
7. Check that all light bulbs are secure in their sockets.
8. Reconnect power.
Complete Installation
1.
Install grease filters. See the "Cleaning" section.
2. Check operation of the Hood Insert blower and lights.
See the "Hood Insert Use" section.
3. If the hood insert does not operate, check to see
whether a circuit breaker has tripped or a hous
hold fuse has blown.
Disconnect power supply and check that the
wiring is correct.
NOTE: To get the most efficient use from your new hood
insert, read the "Hood Insert Use" section.
G
E
F
E.Home power supply
F. UL listed or CSA approved ¹⁄2" (1.3
cm) strain relief
G. Ground Wire tab
Description of the Hood
2
1
1.
Blower and light controls
2.
LED lamps
Control
The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
The hood controls are located on the center side of the range
hood.
Recessing Knobs
•
You can hide control knobs by depressing them until flush
with the hood body.
•
Pressing the knobs again will lower the knobs, and enable
the user to operate the lights and blower.
4
3
3.
Grease filter handle
4.
Grease filter
9