Publicidad
Idiomas disponibles
Idiomas disponibles
Operating the unit
12.4 Starting/stopping ultrasonic cleaning
The cleaning liquid also heats up in ultrasonic operation without heating. Especially during continuous
operation, the cleaning liquid can become hot due to ultrasonic operation.
The cleaning duration is set.
The ultrasound mode has been changed, if applicable.
The cleaning temperature is set (for units with heating).
Press the Start/Stop button to begin ultrasonic cleaning. Ultrasonic cleaning stops
automatically after the set time.
The LED indicator for cleaning duration flashes green during ultrasonic cleaning.
The LED indicator for cleaning duration lights up green when ultrasonic cleaning is
complete. A brief audible signal tone also alerts you to the end of cleaning.
Press the Start/Stop button again to stop ultrasonic cleaning before the end of the set
cleaning duration. The LED indicator for cleaning duration will go out.
Important! Check the temperature of the cleaning liquid regularly, especially when cleaning sensitive
objects.
If the cleaning temperature is too high, allow the cleaning liquid to cool down or replace the cleaning
liquid.
Ultrasonic cleaning is complete. Check the cleaning result.
NOTE! Automatic safety shut-off is activated after 8 hours of unit inactivity. The LEDs turn off.
The unit can be switched on again by pressing a button or turning a rotary knob.
12.5 Remove cleaned objects
ü The end of ultrasonic cleaning is indicated by the End of cleaning symbol or, where applicable, an
acoustic signal.
1. Carefully remove the lid, and allow any dripping water to drip into the tank. Then, place the lid upside
down next to the unit to use as a drip tray.
CAUTION! If using high cleaning temperatures > 50 °C, allow the liquid to cool down first
or use suitable heat-insulating protective gloves.
2. Lift the basket or insert out of the tank, allow the excess fluid to drain briefly, and place it on the
upturned lid.
ðThe objects are now clean. Check the cleaning result.
è Check the fill level if you intend to start another ultrasonic cleaning process.
è Switch off the unit. If the fluid is dirty or will not be used again, empty out the liquid. See the section
Draining the unit for information.
20 / 24
Renfert GmbH
Easyclean TEC
Publicidad
