Publicidad
Idiomas disponibles
Idiomas disponibles
- Water cleaners with the
"Total Stop" device should be
considered as off when the
omnipolar switch is in the "O"
position or the plug is unplug-
ged from the socket.
- When the water cleaner is not
used, close the safety device
on the handle (fig. 9).
- Dry use of the water cleaner
causes serious damage to
pump gaskets.
ATTACHING THE DETER-
GENT INTAKE KIT (fig. 10)
(optional accessory)
To suck up the detergent
solution, fit the kit supplied on
to the water output of the high
pressure washer.
USE OF THE DOUBLE LAN-
CE
(fig. 11)
(optional ac-
cessory)
The double lance allows the
operator to select a low or high
pressure jet. The pressure is
selected with the gun in pos.
1.
High pressure: pos. 2.
Low pressure and detergent
intake: pos. 3.
USING THE ADJUSTABLE
HEAD (Fig.12)
(optional
accessory)
The adjustable head enables
you to select a low or high
pressure jet. The pressure is
selected by rotating the head.
High pressure pos. A.
Low pressure pos. B.
English
FIG.9
FIG.10
FIG.11
FIG.12
ADVICE ON USING DETERGENTS
!
Warning
This cleaner has been designed for use with the detergents
supplied or recommended by the manufacturer.
The use of other detergents or chemicals may influence the
safety of the cleaner.
1) For environmental compatibility, we recommend a reaso-
nable use of detergents, according to the instructions on the
pack.
2) From the range of recommended products, choose the
one most suited to the washing job to be done and dilute it
with water according to the instructions on the pack or in the
catalogue of the detergents most suited for the type of hot or
cold water cleaner.
3) Ask your dealer for the detergents catalogue.
OPERATING PHASES FOR CORRECT CLEANING WITH
DETERGENTS.
1) Prepare the solution of detergent at the concentration
most suitable for the type of dirt and the surface that is to be
washed.
2) Detach the extension from the handgrip and fit the double
lance, lance with adjustable head or detergent kit. Operate the
high pressure washer, activate the detergent suction control
on the lance (figs. 10, 12) and spray the surface to be washed,
working from the bottom upwards.
Leave to work for a few
3) Rinse the whole surface well from top to bottom at high
pressure.
4) After using with detergent, flush out the intake circuit; place
the detergent suction hose (fig. 8) in a tank of clean water and
let the pump run for 1 minute with the dosing tap turned fully on
and the lance in detergent delivery condition.
REGULATING PRESSURE
This chapter concerns only
those models provided
with the "pressure regula-
ting" device. The pressure
regulator, fig. 13, allows the
operator to adjust the working
pressure.
When knob C is
turned in an anti-clockwise
direction (B) (minimum), the
working pressure is reduced.
- 25 -
minutes...
FIG.13
Publicidad
