Rear Panel - Omnitronic CDT-200 Manual Del Usuario

Playback-mode:
If you press the Cue-button during playback, the player returns to the track-start or the Cue-point and goes
into Pause-mode.
Please refer to the explanations under 6.7 Cueing.
6. PLAY/PAUSE-BUTTON
With the Play/Pause-button, you can start the playback and stop it again. Please refer to the explanations
under 6.4 Play/Pause.
7. DISPLAY
LCD-display for displaying the different modes and functions. Please refer to the explanations under 6.3
LCD-display.
8. TIME/OUTRO-BUTTON
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed), outro-function (Outro) or total remain time (Total Remain). For activating the Outro-
function, the display needs to show „Outro". In this mode, the last 30 seconds of every track are played.
9. PITCH SELECT-BUTTON
You can select the speed-adjusting range between +/- 8 %or +/- 16 % by pressing the Pitch Select-button
and selecting the desired range.
10. PITCH BEND-BUTTONS
With the Pitch Bend-buttons, you can adjust the playback-speed temporarily by +/- 16 %. Furthermore, you
can synchronize the bass-beat of two different signal-sources with these buttons. Please refer to 6.6
Synchronisation of the playback-speed.
11. PITCHFADER
You can adjust the desired speed with the Pitchfader after pressing the Pitch-button. The display shows the
current percentage. If the Pitch-button is not pressed, any adjustment on the Pitchfader will have no effect.
12. OPEN-BUTTON
Press this button to open the Disc compartment-door. The door opens.
13. DISC COMPARTMENT-DOOR
To enter the disc.

4.3 Rear panel

14. AC CONNECTION
15. POWER SWITCH
Press this button to start operation.
16. VOLTAGE SELECTOR
Make sure that the indication corresponds to the available voltage.
17. AUDIO OUT-SOCKETS
The music-signal of these sockets is analogue. Connect the output to the respective input of your mixer.
17
18/39
14
15
16
10602279_V_1_2.DOC