Installation; Operation; Setup; Cd-Tray - Omnitronic CDT-200 Manual Del Usuario

5. INSTALLATION

Install the CD-player on a plane surface.
Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.
Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.
CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages. Only plug the power-plug into safety-sockets.
Connect your CD-player with the mains.

6. OPERATION

6.1 Setup

Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.

6.2 CD-tray

Press the Open-button to open the Disc compartment-door. The door opens. Insert your CD into the CD-
compartment and close the compartment-door.
Make sure that you only hold the CD with 2 fingers on the edge. Avoid touching the inside area of the CD.

6.3 LCD-display

If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the total number of tracks and the total playback time are shortly displayed.
The player jumps to the first track and is in the Pause-mode (Play/Pause-LED flashes). Please note that the
player automatically jumps to the section where the music starts.
Above "TRACK" the track number is displayed. Above M (MIN), S (SEC) and F (FRAME) the track remain
time is displayed.
By using the Time-button, the time-indication can be switched from track remain time (Remain) to track
playback time (Elapsed), outro-function (Outro) or total remain time (Total Remain). For activating the Outro-
function, the display needs to show „Outro". In this mode, the last 30 seconds of every track are played.
Above the time-indication, 10 bars are displayed showing the remaining track-time visually. The shorter the
track remain time becomes, the less bars are displayed. 30 seconds before the track-end, the bars in the
display start flashing.
The indication "SINGLE" means that the CD-player is in Single-mode. The current track is then played once
and the player goes into Pause-mode at the beginning of the next track. By pressing the Single-button, the
CD-player changes into normal playback mode and the display shows "CONTINUE".
The indication "0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-button has to be pressed), the respective percentage is indicated in the display.

6.4 Play/Pause

In the Pause-mode the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.
19/39 10602279_V_1_2.DOC