Selecting A Track Via The Track-Buttons; Synchronisation Of The Playback-Speed; Cueing; End Of Operation - Omnitronic CDT-200 Manual Del Usuario

6.5. Selecting a track via the Track-buttons

You can select the desired track via the Track-buttons.
In order to play a track from the beginning, press the Track-buttons until the desired track number is
displayed. If you hold the respective Track-button, the CD-player will run through the track numbers until you
let the button loose.
«-button:
If you press the «-button once, playback starts at the beginning of the previous track. If a track is already
played back, you can start the current track from the beginning.
+10-button:
By pressing the +10-button, the CD-player jumps 10-stepwise from track number to track number (e. g. 06,
16, 26, 06).
»-button:
If you press the »-button once, the playback starts at the beginning of the next track, if you press it twice the
following track, etc.
Please note that the CD-player calls the track up in the mode you pressed the Track-button. If the CD-player
is in the Play-mode at track 1 for example and you press the »-button, the player jumps to track 2 and
immediately starts playback.

6.6 Synchronisation of the playback-speed

You can synchronise the CD player and another signal-source while cueing with the headphones via the
mixer.
Possibility 1:
Put the CD-player into playback-mode and cue with the headphones. Synchronise the playback-speed via
the Pitchfader of the CD-player (Pitch-button has to be pressed).
Possibility 2:
If the two signal-sources only differ in the bass-beat, you can synchronise via the Pitch Bend-buttons or the
Scratch-wheel.
Put the CD-player into playback-mode and cue with the headphones. Synchronise the bass-beat via the left
or right Pitch Bend-button.

6.7 Cueing

The player is in Playback-mode.
Press the Loop In/Fly Cue-button and the Cue-point is memorized. The red Cue-LED shortly flashes twice.
As soon as you press the Cue-button, the player returns the Cue-point and goes into Pause-mode.

6.8 End of operation

Before you switch off the device, please make sure that no CD remains in the player.
Also make sure that the CD-tray is completely closed before you switch off. If this is not the case, switch the
device on again and close the tray with the Open/Close-button.

7. PRECAUTIONS

This CD player cannot be compared to conventional Hifi CD players - even if they have almost the same
appearance. This player is much more rugged in order to withstand the strenous road use and consistent
transports of mobile discotheques. We recommend to put the CD player on plastic foam or on rubber feet in
order to avoid skipping, which is caused by vibrations of low frequencies. The same thing holds true if the
CD player is mounted in a rack an the rack is exposed to such frequencies.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
20/39 10602279_V_1_2.DOC