For Your Information; For Your Safety - Hazet-Werk 7000 sTAC Serie Instrucciones De Uso

1 . General information
The torque wrench with built-in angle gauge was
developed for controlled tightening and undoing of
screw joints with left or right-handed threads.
Every HAZET torque wrench with built-in angle
gauge is calibrated to DIN EN ISO 6789 for torque and to fac-
tory specifications for actuation angle, and is supplied with serial
number, operating instructions and certificates.
For intended use of the electronic torque wrench with built-in
angle gauge, it is essential that all safety and other information in
these operating instructions is adhered to. This is the only way to
guarantee long-term, problem-free usage of this precision tool.
For this reason, always keep these operating instructions together
with your HAZET tool.
NOTE: Follow all safety, warning and operating
instructions for safe and problem-free operation of
the tool and to prevent any immediate risks. Please
pay attention to the following symbols!
1 . General information
CAUTION! Particular specialist knowledge and/or suit-
able training are/is required to use and repair the
device.
This device was developed and manufactured according to the
recognized technical norms and standards valid at the time and
is considered to be operationally reliable. Nevertheless, the tool
can present a danger when it is not used as intended, in an inap-
propriate way or by unqualified personnel. Please make sure that
any person using this device or carrying out maintenance work
carefully reads these operating instructions and fully understands
all information given before using the device.
2 . Operator's liability
• Keep the operating instructions together with the tool at
all times. If the operating instructions have been mislaid or
made unusable, please contact your HAZET partner.
• Check that the torque wrench with built-in angle gauge
is fully functional before every use. Do not use the tool
set if its functionality cannot be ensured or if damage is
detected. If the tool is used its full functionality not being
guaranteed, there is a risk of serious injury, health problems
and material damage.
• Only use the torque wrench with built-in angle gauge
when it is in perfect working condition. If the device does
a

For your information

2 . Explanation of symbols
READ THE OPERATING INSTRUCTIONS!
NOTE!
WARNING!
CAUTION!
QUALIFIED PERSONNEL ONLY!


For your safety

not work properly, it must be removed from service and
inspected.
• All safety, warning and operation instructions on the tool
must remain legible. Any damaged labels or stickers, as
well as the display cover/membrane keyboard, must be
replaced immediately.
• In addition to the safety advice given in these operat-
ing instructions, the general safety regulations, accident
prevention regulations and environmental protection regu-
lations relevant to the application of this tool are to be
observed and adhered to.
• All safety equipment must always be within reach and
should be checked regularly.
• Ensure that you are familiar with how to operate the torque
wrench with built-in angle gauge before use and practice
how to use the tool. Check carefully to make sure all pro-
gramed settings are correct before use. The quality of your
screw work depends on these settings.
The owner of this tool is obliged to observe the oper-
ating instructions and instruct any users of this tool
according to the operating instructions.
This symbol indicates advice that is helpful when
using the tool.
This symbol marks important specifications, dan-
gerous conditions, safety risks and safety precau-
tions.
This symbol marks advice which if disregarded
results in damage, malfunction and/or functional
failure of the device.
The tool may only be used by qualified
personnel. Handling by non-qualified
people may lead to injuries to persons or
damage to the tool or the workpiece.
19