Manual Setting Of Memory Switch - Citizen CT-S280 Manual De Usuario

5.3 Manual Setting of Memory Switch

Memory switches can be set manually or by a command.
For manual setting, refer to the next page.
The function of each memory switch is shown in the following table. (The
white-on-black characters
Switch No.
Memory SW1-1 Power ON Info
Memory SW1-2 Buffer Size
Memory SW1-3 Busy Condition
Memory SW1-4 Receive Error
Memory SW1-5 CR Mode
Memory SW1-6 Reserved
Memory SW1-7 DSR Signal
Memory SW1-8 Reserved
Memory SW2-1 Reserved
Memory SW2-2 Reserved
Memory SW2-3 Spool print
Memory SW2-4 Full col print
Memory SW2-5 Resume aft PE
Memory SW2-6 Reserved
Memory SW2-7 Reserved
Memory SW2-8 PNE sensor
Memory SW3-1 Reserved
Memory SW3-2 Reserved
Memory SW3-3 Parallel 31 Pin
Memory SW3-4 Reserved
Memory SW3-5 Reserved
Memory SW3-6 Reserved
Memory SW3-7 CBM-270 mode
Memory SW3-8 Resum Open Err
are factory setting.)
Setting
— 22 —
0 (OFF)
Send
4k bytes
Full/Err
Print "?"
Ignored
Fixed
Invalid
Fixed
−
Fixed
Invalid
LineFeed
Print next line
−
Fixed
Valid
Fixed
Fixed
Valid
Fixed
Fixed
Fixed
Invalid
Close
1 (ON)
Not send
45 bytes
Full
Invalid
LF
−
Valid
−
Fixed
−
Valid
WaitData
Print top
Fixed
−
Invalid
−
−
Invalid
−
−
−
Valid
Command