ETI 50240161 Manual De Instrucciones página 2

DOwNrOD MOuNTINg INSTALLATION
Driver Box Cover Plate
Knock Out Hole
Remove the driver box cover plate from the fixture
3c
housing.
Connect the fixture housing to the mounting
6c
bracket and secure with 2 screws on each side.
TANDeM MOuNTINg INSTALLATION
MOTION SeNSOr INSTALLATION
nOTe: The fixture is compatible with the ETI model #
70201101-2 motion sensor.
Knock Out Hole
Punch out the knock out hole.
1
bATTery bAck-uP INSTALLATION
1
Make the electrical connections.
WarninG: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could lead to electric shock, fire, or
other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the circuit breaker. • Risk
of fire or electric shock. Installation requires a person familiar with the construction and operation of the light fixture's/luminaire's electrical system and the hazard involved. If not
qualified, do not attempt installation. Contact a qualified electrician.
nOTiCe: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna, increase the separation between the equipment and the receiver, connect the equipment into an outlet on a circuit different from that to which
the receiver is connected, and consult the dealer or an experienced radio/TV.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
H
If needed, use screws to connect the 1/2" Downrod
4c
Mount or 7mm Threaded Downrod Mount to the
mounting bracket.
Make the electrical connections. See step 8a and
7c
9a in the Suspension Mounting Installation section.
I
If tandem mounting is desired, place the ends of fixtures together and match the screw holes on the bracket to
1
the fixtures and insert the 8 screws.
2
Maximum number of fixtures that can be linked together depends on local electrical codes.
2
Model # 70112202-2 / 70114402-2
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
1-855-eTI-SSLI (1-855-384-7754) www.eTiSSL.com
H
CC
Make the electrical connections.
Feed the wires from the downrod through the
5c
mounting bracket and use a nut to secure the
mounting bracket to the downrod.
Restore power at the electrical panel.
8c
Model # 70112201 -2 / 70114401-2